hemisphere gps trimble survey controller

Thales Mobile Mapper CE with EGNOS correction if available Leica Zeno 10 with SKPOS correction in real timeĢs in continuous mode/1s per point in vertex mode Leica GS20 with Beacon correction in real time Trimble GeoXH 6000 series standalone code measurementsĪshtec Mobile Mapper 100 with EGNOS correction STONEX S9 III with GETAC PS236 controller with SAPOS/EGNOS correctionĮxternal antenna ASH 111660 L1 GPS + GLONASSĪshtec Mobile Mapper 100 with EGNOS correction if available (!)ĭGPS post processing (GNSS Solutions v 3.60.1 ) Microsoft Windows Mobile 6.5.10 and VOK Mobil 1.2.217.110ĪrpentGIS v. Trimble Geo 7X GPS + GLONASS with an external BluetoothTrimble Nomad 900GXC handheld Trimble Geo 7X GPS + GLONASS with an external Bluetooth Trimble Nomad 900GXC handheld SX Blue II (Geneq) with an external Bluetooth More information on the device settings, measurement method (number of positions per vertex) and protocol used during the validation test could be requested directly to the MS concerned.Īrrow 100 (EOS) with an external Bluetooth Trimble Nomad 900GXC handheld xls file must be created and filled in for each of the tested parcels. The spreadsheet must filled in with the area measurements and reference values (i.e.

Information concerning the JRC tool validation method can be found ).įor the analyses, an xls template (with instructions) can be downloaded HERE.

The statistical analysis of the measurements was made by JRC, or checked by JRC when the MS did the analysis by themselves. The measurements were carried out by the Member States (MS) in accordance with the JRC guidelines on test parcels selected by the MS. GNSS devices validated by Member States or device distributors However, the single tolerance value shall not exceed 1.25 m.”Īs a consequence, only validated tools with a buffer tolerance at least <= 1 m can be use for parcel area measurement.

For this purpose the measurement tools used shall be validated for at least one validation class of buffer tolerance below the single value. (EU) No 809/2014 stating that “A single value buffer tolerance shall be defined for all area measurements performed using GNSS and/or orthoimagery. The lists have been updated in order to take into account the new rules defined by Article 38 (4) of Commission Implementing Reg. GNSS devices and VHR ortho imagery already validated/certified

1.6 VHR Ortho imagery Exceeding 1 m Buffer width.

1.5 VHR Ortho imagery validated by Member States.

1.4 GNSS devices validated by Reference Laboratories with the buffer width exceeding the maximum value imposed by EU Regulation.

1.3 GNSS devices validated by Reference Laboratories.

1.2 GNSS devices validated by Member States with the buffer width exceeding the maximum value imposed by EU Regulation.

1.1 GNSS devices validated by Member States or device distributors.

1 GNSS devices and VHR ortho imagery already validated/certified.

Hemisphere gps trimble survey controller